An insulated 6 liter (1.6 gallon) stainless steel hot water heater. 12 volt heating element, 200W, requires 10 gauge wire and a 20 amp circuit breaker. This unit will provide 1.6 gallons of water at 180 F (82 C) that can be blended with cold water to triple the volume of usable water. Enough warm water for a couple of good showers. Unit includes
The heat exchanger can produce warm water after 1 hr and reach full temperature after 2 hours. We suggest turning the water heater on two hours before reaching camp.
The tank is neoprene insulated and stores hot water, so you'll have hot water when you arrive at camp, and warm water to clean up the following morning.
This unit can be integrated with our shower mixer and pressure activated electric pump.
We can provide you with typical installation instructions, and the hardware to plumb it depending upon your application. We also fit these units at our shop if you prefer professional installation.
12 volt unit, requires a 20 amp resettable breaker and it is recommended that the power circuit is tied to a relay shutting power off the the hot water heater when the vehicle ignigtion is switched off.
The tank is 13.4" L x 8.7" H x 7.9" W ( 340mm x 220mm x 200mm)
Weight 6.6 lb. (3.0 kg)
Special Order 2-3 weeks